Cyclone separator for shop-vac for 25€

I’ve been thinking about building a cyclone separator for my shop-vac for a while now, and I finally decided to go ahead and do it. I was planning on building a Thien cyclone, and was shopping for the required buckets and bits of pipes, when something else caught my eye in the store. It was a vacuum cleaner for fireplace ashes, on special for only 25€. It had pretty much all the pieces I was going to buy anyway, and they were partially assembled the way they need to be, so I bought it.

In short: A Nilfisk shop-vac and a cheap ash-vac:

IMAG0212

..became a shop-vac with a cyclone separator:

IMAG0213

Building this was really simple. First I just unscrewed the motor/filter assembly from the container. After that, the only thing that actually took some doing was hacking a hole in the center of the lid, and hot-gluing the aluminum nozzle pipe in the hole as the exhaust port:

IMAG0214

The rest of it just fit together. All the hoses and connectors were the exact correct size, like they were made for each other.

Does it work? Yes. I did a test run by cleaning up the workshop, and here are the results:

IMAG0211

There is a small amount of fine dust in the Nilfisk’s container. All of the larger pieces and very nearly all of the fine dust are in the separator. There is naturally a decrease in the suction power, but that’s nowhere near bad enough that I’d need to even consider not using the separator.

I might consider adding the baffle in the cyclone separator later, but for now the system seems to work quite well enough without it.

All in all, for about 30 minutes of work and 25€, not bad at all!

This entry was posted in Making stuff. Bookmark the permalink.

One Response to Cyclone separator for shop-vac for 25€

  1. vin1234 says:

    The best solution is the use of a cyclone separator in conjunction with a paper bag and a pleated cartridge filter inside the ShopVac. This cyclone separator will remove most particulate matter (including fine sanding dust) from the air stream allowing mostly clean air to return to the ShopVac. More info

Leave a Reply

Your email address will not be published. Required fields are marked *